Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Cap & Crown Cost in Schaumburg?
Chimney cap and crown work in Schaumburg typically runs $285 to $1,650 depending on what’s being done. A standard stainless cap with installation lands around $285 to $650. A crown repair using mortar or a crown coating product runs about $450 to $900, and a full crown rebuild sits at $900 to $1,650. Most single-family homes in Schaumburg fall in the $400 to $800 range for a cap replacement or crown repair done together.
We’re Duke Chimney Sweep, and cap and crown work is one of the most common calls we take in Schaumburg. It’s also one of the most misunderstood line items on a chimney invoice. Crowns crack. Caps rust out or blow off. When they fail, water gets into the flue and masonry, and the repair bill climbs fast. This guide breaks down what things actually cost in the Schaumburg market in 2026, what pushes the number up or down, and where you can reasonably save without cutting corners.
Key Takeaways
- Standard chimney cap with installation: $285 to $650
- Crown repair with coating or mortar: $450 to $900
- Full crown rebuild: $900 to $1,650
- Cap and crown done together usually saves $75 to $150 versus booking separately
- Custom or oversized caps for large masonry flues run higher than stock sizes
Chimney Cap & Crown Cost Breakdown (2026)
Here’s how the numbers break down for a typical single-family home in Schaumburg. These are installed prices, not parts-only. They reflect what homeowners in this market are actually paying for professional work.
| Line Item | Typical Cost Range | Notes |
|---|---|---|
| Standard stainless steel cap (single flue) | $285 – $520 | Stock sizing, single-flue masonry chimney |
| Custom or multi-flue cap | $450 – $650 | Fabricated to fit, common on larger Schaumburg masonry chimneys |
| Copper cap | $550 – $1,100 | Copperfield and similar specialty products, long service life |
| Crown crack repair (sealant or mortar patch) | $450 – $650 | Hairline to moderate cracks, sound crown structure |
| Crown resurfacing with crown coating | $550 – $900 | HeatShield and specialty crown coatings extend life without rebuild |
| Full crown rebuild (remove and re-pour) | $900 – $1,650 | Failed crown, crumbling mortar, or significant displacement |
| Cap and crown together | $650 – $1,350 | Most common combo we quote in Schaumburg |
The single biggest line-item swing is cap material. Stainless steel is the workhorse for most homes. Copper costs more but lasts decades longer and many Schaumburg homeowners choose it on homes where the chimney is visible from the street. On the crown side, the swing is structural: a crown that just needs sealing is a different job from one that’s cracked through and needs rebuilding. We work with HeatShield resurfacing technology, which lets us restore a flue without a full teardown in many cases. That’s a real cost difference on a crown-plus-flue job, and it’s why we try to repair before we recommend rebuilding.
If you’re trying to get a full picture of the chimney top, the Chimney Cap & Crown in Schaumburg page walks through what each component does and when it needs replacing. This page is about the money.
What Affects Chimney Cap & Crown Pricing in Schaumburg
Two caps on the same block can cost different amounts. A few factors drive most of the variation.
- Cap material and gauge. A builder-grade galvanized cap runs less than a stainless cap. Stainless lasts longer, especially against Schaumburg’s freeze-thaw cycles, and the price difference usually pays back. Copper costs more again. We stock and specify DuraFlex, Gelco, Olympia Chimney, and Famco components so the hardware matches the job, not a hardware store shelf.
- Crown condition. A crown with a few surface cracks can be sealed and coated. A crown that’s crumbled at the edge or pulled away from the flue needs more work. If the crown is failing, water is likely already getting into the masonry, and that changes the scope.
- Flue count and shape. A single round flue is the simplest job. A multi-flue masonry chimney or an irregular older flue needs a fabricated cap and sometimes a flexible liner system like DuraFlex to handle the retrofit. That’s a real cost variable and one reason a phone quote without seeing the chimney is only a ballpark.
- Home age and masonry condition. Many Schaumburg homes date to the 1970s through 1990s, and some of that masonry has been through dozens of winters. Spalling brick, cracked mortar joints, and a crown that’s taken on water all affect how much prep work the job needs before the cap or crown goes on.
- Chimney height and access. A tall chimney or one with tricky roof pitch takes more setup. Steep-roof and height work is genuinely dangerous, which is one reason we don’t recommend homeowners attempt cap or crown work themselves.
- Whether you’re bundling with a sweep or repair. Booking a cap or crown job alongside a cleaning or flue repair usually lowers the combined price, since the crew is already on the roof.
We do a full inspection before quoting, because guessing at a crown’s condition from the ground is how homeowners end up with a surprise on the invoice. That inspection is part of the free estimate.
How to Save on Chimney Cap & Crown
There are a few practical ways to keep the number down without leaving the chimney exposed.
- Book the cap and crown together. Two separate visits cost more than one. If both need attention, do them on the same trip. That alone can save $75 to $150 in many cases.
- Choose stainless over a cheaper cap. A galvanized cap can cost less up front but may need replacing years sooner. Stainless is the smarter long-run buy, and it’s what we recommend for the majority of Schaumburg homes.
- Repair the crown before it fails. A crown that’s caught early can be sealed and coated for less than a rebuild. That’s the “restore before you replace” principle, and it applies directly here. Letting a crack run through several winters usually pushes you from a coating job into a rebuild.
- Ask about resurfacing instead of relining. If a damaged crown is letting water into the flue, HeatShield resurfacing can often restore the flue without a full rebuild. Not every job qualifies, but it’s worth asking about.
- Get the estimate in writing, with line items. A quote that says only “crown repair” tells you nothing. You want to see what’s being repaired, patched, or rebuilt and what materials are going on.
We offer free estimates, and there’s no pressure to book on the spot. Call (844) 660-6510 and we’ll come look at the chimney and give you a straight number for your specific roof, flue count, and crown condition.
FAQs – Chimney Cap & Crown Cost
How much does a chimney cap cost in Schaumburg?
A standard stainless steel chimney cap in Schaumburg typically costs $285 to $520 installed. Custom or multi-flue caps run $450 to $650, and copper caps run $550 to $1,100. Call (844) 660-6510 for a free estimate on your specific chimney.
How much does it cost to repair or rebuild a chimney crown in Schaumburg?
Crown repair with mortar or sealant runs $450 to $650, crown resurfacing with a coating product runs $550 to $900, and a full crown rebuild runs $900 to $1,650. The right option depends on whether the crown is cracked or crumbling. Call (844) 660-6510 for an estimate.
Is it cheaper to repair the crown or rebuild it?
Repairing a crown is cheaper than rebuilding it, often by $400 or more. If the crown has surface cracks but is structurally sound, a sealant or coating job will usually hold. If it’s crumbled or pulling away from the flue, a rebuild is the safer call. Call (844) 660-6510 to find out which applies to your chimney.
Why do Schaumburg chimneys seem to need crown work so often?
Schaumburg’s freeze-thaw pattern is rough on masonry. Water gets into a small crack, freezes overnight, expands, and widens the crack. Across a winter, a hairline crack becomes a real one. Many Schaumburg homes date to the 1970s through 1990s, so a lot of that original masonry has had decades to go through this cycle. Call (844) 660-6510 and we’ll tell you whether the crown needs repair or replacement.
Can you do a chimney cap and crown job the same day?
Yes, in most cases a cap installation and crown repair can be done in one visit. A full crown rebuild may take longer depending on weather and how much prep the masonry needs. Call (844) 660-6510 to schedule.
If you’re not sure whether your chimney needs a cap, a crown repair, or both, the services we offer across the Schaumburg area cover the full picture, from chimney sweeping to repair to dryer vent cleaning. We like homeowners to have the whole picture before they spend a dollar. That’s how you build a name in a town this size.
Give us a call at (844) 660-6510. We’ll come out, take a look at the crown and cap, and give you a honest number for the work. No pressure, no upsell.
Pricing reflects the Schaumburg market as of 2026. Duke Chimney Sweep offers free estimates – call (844) 660-6510.
What Our Customers Say
"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
— Chris Ziegler"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Michelle Meyer"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Divya Rao